2 posts • Page 1 of 1
The 20x1 SIP for the LCD (ASSY1) should be installed on the PCB before Q2 and C17. Q2 and C17 are seriously in the way of soldering the three right-most pins of the SIP. L5 is a little bit in the way, too, but if Q2 weren't there that would give you one open side. Similarly, the two 2x1 SIPs used as standoffs for the opposite edge of the LCD (ASSY2 and ASSY3) should be installed on the PCB before BOB5 and C29.