We found a component packing mistake in a small batch of 13804K kits that have been shipped out. The mistake was that the 10K SMD resistors provided were 5 instead of 6 as specified in the part list. That's to say one 10K SMD resistor is missing. Luckily we only need 5 10K SMD resistors for the scope to function. If any users who purchased these kits you just need not to install R41. Without R41 will not affect any function and performance because R41 is not used at all in current design. It is provided just in case we might use it in future by changing firmware. But now we are sure we don't need this resistor for good.
We sincerely apologize for the inconvenience that this mistake may have caused.
1 post • Page 1 of 1