Counterfeit 062?

Counterfeit 062?

Postby mwm » Tue Aug 16, 2016 3:41 am

On looking at my 062 kit, the LCD module does not have any signal labels on it, just pin 1 on one side. Could this be a counterfeit?
Last edited by mwm on Tue Aug 16, 2016 9:59 pm, edited 2 times in total.
mwm
 
Posts: 44
Joined: Fri Jun 24, 2016 2:35 pm

Re: Countries 062?

Postby jye1 » Tue Aug 16, 2016 1:55 pm

Can you post photo showing the board?
jye1
 
Posts: 1221
Joined: Wed Feb 20, 2013 4:58 pm

Re: Counterfeit 062?

Postby mwm » Tue Aug 16, 2016 9:45 pm

Ok, I've attached images of the component side of both the LCD module and the main board.
Attachments
IMG_20160816_162636.png
main board
IMG_20160816_162553.png
LCD module
mwm
 
Posts: 44
Joined: Fri Jun 24, 2016 2:35 pm

Re: Counterfeit 062?

Postby jye1 » Thu Aug 18, 2016 2:40 am

Thank you for the photos. This board doesn't look counterfeit. The LCD was from a different supplier and has different markings.
jye1
 
Posts: 1221
Joined: Wed Feb 20, 2013 4:58 pm

Re: Counterfeit 062?

Postby mwm » Thu Aug 18, 2016 5:24 am

In that case, I think I have a dead lcd module. It doesn't light up at all. I'll post voltages tomorrow, but most of them seemed ok, though many were 1 volt higher than listed, which I assume is because I use a 10 volt ps.

But for now, which side should the 20 pin header be attached to? The assembly instructions say the side with the signal labels, but this module has no signal labels on it, just the two pin numbers 1 and 20.
mwm
 
Posts: 44
Joined: Fri Jun 24, 2016 2:35 pm


Return to DSO 062

Who is online

Users browsing this forum: No registered users and 1 guest

cron