Page 1 of 1

FG085 doesn't output SQR waveform

PostPosted: Fri Nov 08, 2013 11:05 pm
by Ronald
Hello,
I purchased a factory assembled FG085 (Main: 08501-130, DDS: 08502-050). Today, I powered it up for the first time.
It outputs SINE, TRI, RMP+, RMP-, STR+ and STR- waveforms, but no SQR.
How to fix this?
best regards,
Ronald

Re: FG085 doesn't output SQR waveform

PostPosted: Tue Nov 12, 2013 3:58 pm
by jye1
Please check the duty cycle setting. It might have been set to 0 or 100. Pressing the '.' button (decimal point) will show you current duty cycle. Press again will allow you change it.