JP1 & JP2 brought to the edge of the mainboard

JP1 & JP2 brought to the edge of the mainboard

Postby MorganFlint » Sat May 16, 2020 10:14 am

I just wanted to share my solution to implement removable jumpers for JP1 and JP2.

As you can see in the attached images, I just used a 2x4 pin header installed in J3, and routed CPU's sides of JP1 and JP2 to the pins in parallel with 3.3V and GND of J3 with thin wires.

This way, if I install the jumpers the CPU enters the serial port flash mode, but without them, J3 (lower row) can still be used for its original purpose (serial wire debug). The upper row can be used to store the jumpers when not in use (as in the first photo).

As a suggestion, a future revision of the mainboard's PCB could include two extra pins at both sides of J3, routed to pins 20 and 44 of the MCU for the same purpose ;)
Attachments
WhatsApp Image 2020-05-16 at 12.13.42.jpeg
WhatsApp Image 2020-05-16 at 12.07.05.jpeg
MorganFlint
 
Posts: 55
Joined: Sat Jun 06, 2015 9:06 am

Return to DSO138mini

Who is online

Users browsing this forum: No registered users and 1 guest